Water evaporation air conditioner cooling

Introduction: Water evaporation air conditioner mainly consists of seven parts: wet curtain, fan, chassis, water distribution system, circulation pump, housing and control system. Its characteristics are: a good water absorption and ventilation performance, the actual heat transfer area is close to 100 times the body surface area; texture is strong, water immersed without deformation; corrosion resistance, the normal service life is quite long; can reach below 5 °C - Cooling effect at 12°C (dry heat up to 15°C). The hotter the air is, the greater the temperature difference is, and the better the cooling effect is!

The water distribution board is injection molded with high-strength engineering plastics. The water distribution method is the principle of natural flow that uses water to flow at a low level. The water distribution board is designed to be slanted, and 30 channels are distributed on the upper surface. The clean water coming up through the distributor, the water flows evenly down the drawtable to the evaporation curtain to ensure that the evaporation curtain is evenly and completely wetted to form a water film. After the strong air volume fan is actuated, the outdoor air is sucked into the evaporative heat exchanger at high speed. The water in the upper water film of the forced evaporative heat exchanger rapidly changes from liquid evaporation to gaseous state, absorbs heat from entering the air, and causes the air temperature to drop at a very fast speed to realize primary evaporation. At this time, the cold air current carries a large amount of negative oxygen ions. The humidity of the cold air when evaporating is high. After the cold air is pressurized by the high pressure scroll and sent into the room through the pipe, secondary evaporation is realized. When the secondary evaporation is performed, the cold air draws heat from the indoor air, and the humidity of the cold air during the second evaporation is low. Because the density of the cold air is larger than that of the hot air, the cold air and the hot gas meet and then quickly sink, occupying the original position of the hot air, and the hot air is lifted to a height of 3-5 meters from the ground. The continuously entering cold air always occupies the interior. Low space to keep the area comfortable with human temperature, humidity and fresh air!

When the air passes through the CELDEK wet curtain paper through the exhaust fan or blower, the wet curtain is in a corrugated shape, and the area of ​​its contact air is close to 100 times the surface area of ​​the body. Our water evaporation air conditioner wet curtain is a wall type wet curtain with a surface area of ​​2 m2. The actual surface area of ​​the water film is close to 200m2. Due to the large surface tension, dust dust will be absorbed by the water. Dust dust will flow into the water tank at the bottom of the water evaporation machine under the water scour. Operate the electronically controlled cleaning switch in the workshop to eliminate! Dust and dust can be filtered by water with an efficiency of more than 90%. If the double-layer wet filter paper filter effect exceeds 96%!

Air Conditioner Cooler Features:

1, completely environmentally friendly products: It is no compressor, no cold coal, pollution-free environmentally friendly products, which is the use of outdoor full fresh air evaporative cooling principle of cooling and convection with the indoor ventilation to achieve the purpose of ventilation and cooling.

2. Low operating costs, quick return on investment: Compared with the traditional compressor air-conditioning series, the power consumption is only 1/8-1/10.

3. The cooling effect is obvious: In the more humid areas (such as the southern region), the effect of significant temperature reduction of about 5-9°C can be generally achieved; in particularly hot and dry areas (such as the north and northwest regions), the cooling rate can reach approximately 10-15. °C or so.

4. The investment cost is low and the construction area is not occupied: Compared with the traditional compressor air-conditioning system, the cost is less than half, and the equipment does not occupy any building area.

5. Keep indoor air clean, clean and sanitary: Exhaust air with open doors and windows is a major feature of evaporative air-conditioners. 100% fresh air replacement keeps people in a natural environment at all times. With a sense of adaptation, the dirty air is discharged outside.

6, easy to maintain and install: the system is simple, easy and quick installation, maintenance, without professional maintenance personnel.

7, to prevent air drying: It can moisturize the skin, and there are certain benefits to the skin.

8, low noise, low vibration: At present in the domestic similar products in the air conditioner in the low noise, allows us to unknowingly get fresh and natural breeze; the body itself does not heat to the surrounding.

Application range:

※ Textile, machinery, ceramics, fine chemicals, metallurgy, glass, hardware, leather and other manufacturing industries;

※ Electroplating, electronics, footwear, printing and dyeing, plastics, garments, printing, packaging, food and other processing industries;

※ Hospitals, waiting rooms, schools, waiting rooms, supermarkets, laundry rooms;

※ Kitchens, vegetable markets, large entertainment centers, underground parking lots, stations and other public places;

※ Greenhouses, flowers, poultry, animal husbandry and other farms;

※ Existing air conditioners and blower equipments are modified and installed.

※ For places with high humidity requirements (such as textiles, planting, etc.), some indoor installations can be used for design.

Source: Suning Guoen Refrigeration Equipment Service Co., Ltd.